Champion Electric Reports High Lithium in Boulders from Initial 2024 Sampling at Quebec Lithium Project, James Bay Territory

Champion Electric Metals
CHAMPION ELECTRIC METALS
July 11, 2024
Champion Electric Reports High Lithium in Boulders from Initial 2024 Sampling at Quebec Lithium Project, James Bay Territory

Toronto, ON – July 11, 2024 – Champion Electric Metals Inc. (CSE: LTHM; OTCQB: GLDRF; FSE:

1QB0) (“Champion Electric” or the "Company") is pleased to announce that the Company has

received results of high-grade lithium from initial geochemical analyses for rock samples from

the 2024 field program at the Quebec Lithium Project in the heart of the Eeyou Istchee James

Bay territory.

The rock samples were taken from the recently reported boulder fields which included boulders

up to 5m X 4m X 2m that stretched 1.7 km up ice and up to 50 metres wide. The sample inventory

consisted of 39 rock samples that were collected in conjunction with geologic mapping. These

samples were submitted to Activation Laboratories in Val d’Or, Quebec along with embedded

blind quality assurance samples and certified reference materials.

Highlights of Significant Results:

• Mineralized pegmatite boulders now define a glacial dispersal train of at least 1.7

km along a NE-SW corridor, defining the Western Prospect (see Fig.1), which

encompasses 2023 till sample EIQ-001 (+52,000 spodumene grains). Clusters of

boulders within this glacial dispersal train are angular to sub-angular and range 0.3 to 5m

in diameter and contain pale green spodumene crystals to a maximum observed

dimension of 35 cm (see Figures 2-3).

• Grab samples collected from these boulders yielded highly anomalous lithium content,

such as 5.83%, 5.78%, and 4.62% lithium oxide (“Li2O”). These lithium values are the

highest encountered to date by Champion Electric at the Quebec Lithium Project.

• Of the 30 grab samples collected from spodumene-bearing boulders, 23 assayed

greater than 1.0% Li2O (see Table 1).

• Sampling continues to better define additional targets through favorable chemistry,

including the key potassium-rubidium ratio (“K/Rb”), at other pegmatite occurrences,

such as the Power Line target and elsewhere on the Charles target which are located on

the western and eastern portions, respectively, of this large land package.

• Trenching with an excavator is underway in the western target corridor based on the

recently reported drill results and the lithium pegmatite boulder field. Company geologists

will collect systematic channel samples using diamond saws across mineralized

outcrops encountered in the trenches

“These samples of glacially transported rock offer solid evidence of an in situ mineral system

with higher grades than we have yet seen in drilling. A local source for these strongly mineralized

boulders is inferred from their size, degree of angularity, and coherent spatial distribution,”

commented President and CEO Jonathan Buick.

“The ongoing trenching program is exposing bedrock for mapping and channel sampling within

the spodumene-bearing boulder field. Additional prospecting is underway to both the southwest

and northeast to extend its known length.”

Overview of the 2024 Field Program:

Fieldwork for 2024 began northeast of the recent mineralized pegmatite discovery, near notable

projects like Patriot Battery Metals' Corvette Project and Winsome Resources' Cancet

Discovery. Efforts include closely spaced till sampling, boulder prospecting, mapping, trenching,

and channel sampling with overburden clearing at the new boulder field, where significant

sampling results were found.

Many of the spodumene-bearing boulders in the dispersal train appear quite different from the

lithium pegmatite encountered in drilling. The size of the spodumene crystals in the boulder field

is often larger than the crystals encountered in drilling, long axis of 35 cm vs 6cm (Figures 2 and

3). Also, the limited spodumene encountered in drilling tends to be green in color, as it is in many

of the surface boulders, but the team has also identified spodumene in boulders that is whiter in

color.

The analytical results also confirmed that the elements used as pathfinders (most importantly Rb

and Cs) are present in highly anomalous amounts (above 1000 ppm for Rb and well above 100

ppm for Cs)*.

The assays also confirmed that the elements used as pathfinders. Rb values >1000 ppm and Cs

100 ppm, are present with significant Rb, up to 5810 ppm and Cs, up to 1250 ppm anomalies

associated with significant Li2O Values. The assays also show K/b rations that are below 15 for

all the samples returning >1% Li, which confirms the obvious enrichment in Rb in the

spodumene-bearing pegmatite samples (Table 1). The K/Rb ratio, as well as Cs are currently

used to select target areas to follow-up with till sampling, prospecting, and trenching.

Champion Electric invites shareholders, potential investors, and stakeholders to follow

the Company’s social media pages for ongoing photo updates of the spring field

program.

Facebook: ChampionLTHM

Twitter/X: @Championlthm

LinkedIn: championelectricmetals\

Sampling techniques and QA/QC

Under the supervision of senior staff, geologists collected grab rock samples from boulders using

rock hammer and chisel. Hence, there is no implied width or extent of the mineralization

encountered in the glacial dispersal train. The location for each sample was recorded using a

handheld GPS. Geologists placed the samples in plastic bags which were gathered into larger

rice bags to organize and facilitate transport to the lab. Champion geologists or contractors

maintained secure custody of the samples until transporting them to Activation Laboratories

(“Actlabs”) in Val d’Or, Quebec for sample preparation and analysis.

Each sample was prepared with the RX1 (crushed and pulverized) method and analyzed after

peroxide fusion using ICP-OES + ICP-MS (Ultratrace-7 method). Champion’s QA/QC protocol

dictates the insertion of certified standards and blanks into the sample stream as a check on

laboratory quality. The sample stream also includes blind duplicates every 50 samples. Actlabs

also routinely inserts certified standards, blanks and pulp duplicates as part of their internal

QA/QC standard procedure. Results from these QC samples are also reported.

The results reported herein exhibited satisfactory results from these QA/QC measures.

Qualified Person

Dr. Eric Hebert, P.Geo., Senior Geological consultant, is a member (#0842) of the Ordre des

Géologues du Québec (OGQ) and a qualified person within the meaning of National Instrument

43-101, and has reviewed and approved the technical information contained in this press

release.

* The Project is at an early stage of exploration, and the Company cautions that the qualified

persons who have reviewed and approved this news release have not verified scientific or

technical information produced by third parties.

Further, proximity to projects containing lithium resources offers no assurance that the rock types

or resources reported by Patriot Battery Metals, Winsome, and others will extend onto the

Project; nor should such proximity be assumed to imply similarity to mineralization and results

reported by other companies in the district.

About Champion Electric Metals Inc.

Champion Electric is a discovery-focused exploration company that is committed to advancing

its highly prospective lithium properties in Quebec, Canada and cobalt properties in Idaho,

United States. In addition, the Company owns the Baner gold project in Idaho County and the

Champagne polymetallic project in Butte County near Arco.

The Company’s shares trade on the CSE under the trading symbol “LTHM”, on the OTCQB

under the trading symbol “GLDRF”, and on the Frankfurt Stock Exchange under the symbol

“1QB0”. Champion Electric strives to be a responsible environmental steward, stakeholder and

contributing citizen to the local communities where it operates, taking its social license seriously,

employing local community members and service providers at its operations whenever possible.

ON BEHALF OF THE BOARD OF CHAMPION ELECTRIC

“Jonathan Buick”

Jonathan Buick, President and CEO

To learn more, please visit the Company’s SEDAR profile at www.sedar.com or the Company’s

corporate website at www.champem.com.

For further information, please contact:

Investor Relations and Communications

Phone: (416) 567-9087

Email: investors@champem.com

Cautionary Statements

Neither the Canadian Securities Exchange nor its regulation services provider has reviewed or accepted responsibility for the

adequacy or accuracy of this press release. This press release may include forward-looking information within the meaning of

Canadian securities legislation, concerning the business of the Company. Forward-looking information is based on certain key

expectations and assumptions made by management of the Company, including closing of the Transactions and the prospectivity of

the Projects for lithium. Although the Company believes that the expectations and assumptions on which such forward-looking

information is based on are reasonable, undue reliance should not be placed on the forward-looking information because the

Company can give no assurance that they will prove to be correct. Forward-looking statements contained in this press release are

made as of the date of this press release. The Company disclaims any intent or obligation to update publicly any forward-looking

information, whether as a result of new information, future events or results or otherwise, other than as required by applicable

securities laws.

The Projects are at an early stage of exploration, and the Company cautions that the qualified persons who have reviewed and

approved this news release have not verified scientific or technical information produced by third parties

Share this post

Subscribe for exclusive updates

You have been subscribed!
Oops! Something went wrong while submitting the form.